ISO/TR TECHNICAL REPORT 19201 First edition 2013-06-01 Mechanical vibration - Methodology for selecting appropriate machinery vibration standards Vibrations mécaniques - Méthodologie pour la selection des normes appropriées relatives aux vibrations des machines Reference number IS0/TR 19201:2013(E) ISO @IS02013 HS under I No reproduction or networking permitted without license from IHS Not for Resale IS0/TR 19201:2013(E) COPYRIGHTPROTECTEDDOCUMENT @IS02013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0/TR 19201:2013(E) Contents Page Foreword ..iv 1 Scope .1 2 International Standards. 2.1 Basic machinery vibration standards. 1 2.2 Related machinery vibration standards .2 2.3 Additional machinery vibration standards .2 3 Terms and definitions .3 4 Evaluation of machine vibration .3 4.1 General .3 4.2 Machinery vibration standards and criteria. .3 4.3 Classification of severity of machine vibration ..4 4.4 Measurement procedures and instrumentation 4 4.5 Vibration standards summaries. .4 5 Measurements made on non-rotating parts ..5 6 Measurements made on rotating parts. ...8 7 Related standards .9 8 Analytical guidelines for selecting the appropriate vibration standard for specific machinery .11 8.1 General .11 8.2 Basic relations for rotating shaft and pedestal vibration ..14 Annex A (informative) Bearing dynamics ..16 Annex B (informative) Pedestal dynamic stiffness ..19 Annex C (informative) Examples of typical values of dynamic stiffness for bearings and pedestals .20 Annex D (informative) Dynamic stiffness of the bearing part combined with the pedestal. .22 Annex E (informative) International machinery vibration standards shown by application area..24 Bibliography 28 ii thout license from IHS Not for Resale