ISO INTERNATIONAL STANDARD 12368 First edition 2001-05-01 Agricultural vehicles Mechanical hook. type connections on towing vehicles Test methods and requirements Véhicules agricoles Liaisons mecaniques de type crochet sur vehicules tracteursMéthodes d'essai et exigences Reference number ISO 12368:2001(E) ISO @ ISO 2001 THS unde Not for Resale ISO 12368:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Casepostale56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland IsO2001-All rightsreserved itted without license from IHS Not for Resale ISO 12368:2001(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(iSc memberbodies).TheworkofpreparingInternationalStandardsisnormallycarriedoutthroughISOtechnica liaison with IsO, also take part in the work. isO collaborates closely with the International Electrotechnica Commission (IEC) on all matters of electrotechnical standardization. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of International Standard ISO 12368 was prepared by Technical Committee ISO/TC 23, Tractors and machinery for agriculture and forestry, Subcommittee SC 2, Common tests. nafionai Organization for StandardizalionServed ii